Prediction of entrained droplet fraction in co-current annular gas–liquid flow in vertical pipes

Aliyu, Aliyu M., Almabrok, Almabrok A., Baba, Yahaya D. , Archibong, Archibong-Eso, Lao, Liyun, Yeung, Hoi, Kim, Kyung Chun, , and , (2017) Prediction of entrained droplet fraction in co-current annular gas–liquid flow in vertical pipes. Experimental Thermal and Fluid Science, 85 . pp. 287-304. ISSN 0894-177

Full content URL:

Prediction of entrained droplet fraction in co-current annular gas–liquid flow in vertical pipes
Author's accepted manuscript
2017-Aliyu et al-prediction of entrained droplet fraction.pdf - Whole Document
Available under License Creative Commons Attribution-NonCommercial-NoDerivatives 4.0 International.

Item Type:Article
Item Status:Live Archive


The entrained droplet fraction is an important parameter in annular two-phase flow, as its correlations are key inputs in flow simulation codes for the prediction of pressure drop and critical heat flux or dryout. Investigators have stressed the importance of extending the validity range of current correlations so that more conditions are covered. This could be achieved for example by including fluids with higher viscosities, a wider range of operating pressures, and increase in the size of pipes used for experiments (most of the data in the literature are from pipes of 50 mm diameter and below). In attempt to improve the latter, experiments were conducted in a 101.6 mm gas–liquid flow loop at Cranfield University’s Oil and Gas Engineering Laboratory and data on the fraction of droplets were collected in the annular flow regime by measuring the film velocity, from which the droplet fraction was calculated. Comparison of the film velocity by this method and by a mass balance showed close agreement. A capacitance Wire Mesh Sensor was used for flow visualisation in order to distinguish between annular and churn flow. In order to arrive at an improved correlation, over 1300 data points were gathered from other published works. These include air–water studies where large pipes of up to 127 mm in diameter were used. The others were from small-diameter pipes and for refrigerant, steam–water, air–water, and air–glycerine flows. Since in the annular regime, the gas flow entrains liquid droplets into the core, their presence alters the properties of the gas core. Therefore, accurate predictions are pivotal for the energy efficient design and operation of facilities in the petroleum and nuclear power industry. The correlation obtained here showed good agreement with the collected databank.

Keywords:Droplet entrainment, Large diameter pipes, Two-phase flow, Sauter mean diameter (SMD), Wire mesh sensor
Subjects:H Engineering > H830 Chemical Process Engineering
H Engineering > H141 Fluid Mechanics
H Engineering > H800 Chemical, Process and Energy Engineering
H Engineering > H300 Mechanical Engineering
H Engineering > H810 Chemical Engineering
Divisions:College of Science > School of Engineering
ID Code:47986
Deposited On:31 May 2022 13:49

Repository Staff Only: item control page